In order to use the electric flat car reasonably and correctly, we need to have a good understanding of its operating procedures, especially for the first-time employees, which can avoid many problems, so as to ensure that the electric flat car can run better. The following is the introduction of some important operating procedures listed by Ruixing lifting editor.
1. The staff who operate the rail electric flat car need to be familiar with the structure and performance of the equipment, and can operate independently after passing the test.
2. In the process of loading and unloading heavy objects, it is necessary to handle them smoothly and gently to ensure the uniform distribution of weight. It is not allowed to use the equipment beyond the specification or overload.
3. When changing the running direction in the process of use, it needs to wait for the movement to stop before reverse starting.
4. Operators should also check the electric flat car equipment according to the relevant inspection requirements.
5. In addition, it is necessary to add oil and lubricate in strict accordance with the lubrication chart of the electric flatbed truck, and carry out it at a fixed time.
6. If there is no obstacle before moving, you need to check the direction before moving.
7. For the battery electric flat car, when the power is insufficient, the battery should be taken out in time and charged according to the requirements, and the standby battery should be replaced for use at the same time. The replacement and charging of the battery should be carried out by a special person.
8. It is not allowed to drive the electric flat car to hit, tow, push or pull the vehicles on the railway.
9. The forward and backward direction signs shall be obvious and consistent with the forward and reverse direction of the switch. There should be no operator leaving or trusteeship.
10. The operation staff should conscientiously achieve "four skills" (be able to use, check, maintain and remove faults) and "three good" (use, manage and repair well)
11. After use, it is necessary to unload the load and cut off the power supply, and clean it according to the system.
12. To regularly check the operation of each part, if the motor, bearing temperature is too high or there is abnormal sound, need to stop in time for inspection.