How To Solve The Noise Of Electric Rail Transfer Cart Problem
The electric rail transfer cart is too noisy when it is running. It should be considered from the following three aspects.
 1.Electric control panel of electric rail transfer trolley When abnormal noise occurs in the control loop, there is a click, most of which are contactor faults (such as contactor contacts and voltage levels do not match the core card, etc.), to deal with faulty contacts The repairs that cannot be repaired must be replaced to eliminate noise handling. 2019-03-28 |
 2.Electric rail transfer cart motor failureImmediately stop, check whether the motor is single-phase operation, or bearing damage and output shaft is not complete failure, which will make the motor abnormal noise, different fault position and sound level, single-phase operation, motor issued The rules, strong and weak humming; bearing damage, will be near the bearing, slamming the ground; and the output shaft, or slightly sweeping the motor, sorghum, without the harsh sound. In short, faults should be identified based on different noises and repaired one by one to restore the normal operating performance of the motor. It is forbidden to use an electric flat transfer cart when the motor is not handled properly. 2019-03-28 |
 3.Electric rail flat car gearbox failure Stop inspection, first determine the gearbox or bearing reducer before the use of lubricating oil, whether to change the oil regularly, if you do not need lubrication, the reducer will not only produce high hum, but also Excessive wear or damage to gears and bearings. 2019-03-28 |