which is the specific reason for flat bed cargo trailer
In the process of using industry transfer trailer towed in general,there are many problems in the gondola,such as side slip,tire tires,chassis damage,etc.,but the most common problem is the problem of direction deviation,which is the specific reason for flat bed cargo trailer.What about the trailer?
1. The road is uneven
Sometimes the flat bed cargo trailer deviation may not be a problem of its own.It may be a road problem.For example,if the road surface is slightly inclined,the car will slowly lean to the lower side;there is a small stone on the road.After the wheel passes over the small stone,it will There is a slight deflection in the free volume range,and the direction will naturally change.Therefore,when judging the deviation of the vehicle,we must also look at the external factors.
2. Loading items are not balanced
We usually don't pay attention when loading items.It may be lighter and lighter.When this happens,industry transfer trailer towed are more prone to deviation.If so,pay attention to balance when loading.
3. Inconsistent tire pressure on both sides
If the tire pressure on the two sides of the industry transfer trailer towed is too large,it will affect the deviation of the vehicle.If the tire pressure of the flatbed tire is high and the side is low,then the adhesion of the vehicle will be different during the driving process.If the pressure is low,then the adhesion will be high,so that the flat bed cargo trailer tire will be biased like the side with low tire pressure.
4. The tire pattern on both sides is inconsistent
We all know that there is a rubber pattern on the surface of the flat bed cargo trailer tire,and the pattern has a certain thickness.With the long-term use of the vehicle,the tire pattern is continuously worn,and the thickness of the pattern is continuously reduced,then the tire with more pattern wear is equivalent to the tire diameter.When it is smaller,the flatbed trailer will drive toward the side where the pattern is worn more.
5. Spring and shock absorber damage
Focus on the lower side to see if there is any over-compression of the spring due to insufficient elasticity and oil leakage from the shock absorber.If there is a problem,of course,it is the replacement of the repair.Change the spring and change the left and right sides together.Don't save too much,otherwise it will become a new imbalance.