The structure of transfer die cart
The transfer die cart consists of a frame, a drive wheel pair, a drive wheel pair, a power supply device, an operating system, and a brake. This configuration can prevent the excessive momentum due to the excessive weight of the carrier member and prevent the resulting loss. Secondly, it is necessary to install alarm devices, limit switches and so on. The transfer die vehicle is safe and pollution free.
1.Transfer die cart adopts frame structure. Frame: frame is made of I-beam. It consists of 4 longitudinal beams and multiple beams. The number of beams with a spacing of 500 mm is determined by the length of the frame.
2.Wheels are made of ZG340640 material, the drive wheel pair: the drive wheel pair consists of wheels, shafts, bearing blocks, bearings, reducers, motors and brakes. The wheel tread is quenched and the hardness is up to HRC280-340. The depth of the 5-6mm axle is 45# round steel for quenching and tempering.
3.The driving wheel pair consists of a wheel, a shaft, a bearing seat and a bearing, and the driving wheel is paired. The materials and bearing types used are the same as those of the drive wheel pair.
4.There is also a battery for long distance transportation. There are three main types of power supply for transfer die cart: power supply for sliding lines, power supply for thin coils, and power supply for low-voltage rails.
5.Compact structure, the operation mode of the electric flat car is button-type operation with the car. The operation buttons are set to advance, retreat, and stop. The motor unit is extended in the lower part of the lower part of the reducer. Reduce the height of the 10t transfer die cart.
6.Reducer adopts electric axle-type special axle-type reducer. The advantage of the axle-type reducer is its compact construction. The transfer die carriage is driven by the secondary gear on the drive shaft. It is beneficial to maintain the reducer and motor under overload conditions.